- Plesk for Linux
How to access Plesk after manual installation on Amazon Lightsail?
Connect to the Lightsail instance via SSH
Once logged in, launch the following command:
# sudo plesk loginCopy URL produced by the command and open it in your browser.
On Plesk initial configuration screen, type name, email and set Plesk admin password
Note: After that, use URL like https://<YOUR_SERVERS_IP>:8443 to access Plesk.
Plesk Web Installer configures Lightsail instance’s firewall as required by Plesk. No additional configuration is required.
Note: if Plesk was installed without Web Installer, follow this instruction to open the Access to Plesk services.