- Plesk 12.5 for Linux
- Plesk 12.0 for Linux
- Plesk 9.x for Linux
The prefork MPM uses multiple child processes with one thread each. Each process handles one connection at a time. On many systems, prefork is comparable in speed to worker, but uses more memory. Prefork's threadless design has advantages over worker in some situations: it can be used with non-thread-safe third-party modules, and it is easier to debug on platforms with poor thread debugging support.
- Developed in Apache 1
- Multiple child processes, 1 thread per child process, child processes handle requests
- Better isolation and stability
- Tested to work correctly with Plesk
- Has higher memory consumption and lower performance over the threaded MPMs
The worker MPM uses multiple child processes with many threads each. Each thread handles one connection at a time. Worker is generally a good choice for high-traffic servers because it has a smaller memory footprint than the prefork MPM.
Developed in Apache 2 in addition to prefork module
Multiple processes, many threads per process, threads handle requests
Uses less memory and provides higher performance
Does not provide the same level of isolation request-to-request as a process-based MPM does
If single thread is suspended/out of control, the entire process will be terminated, affecting all of the threads
Requires a thread-safe processor to handle dynamic content
Not supported by Plesk
Each module has a different set of the configuration directives in the Apache webserver configuration file:
In the RedHat-based Linux distributions, Apache webserver is configured to run with the prefork module by default. Technically, you could switch it to "worker" if you decide that this would suit your needs better, however keep in mind the warning below.
Plesk was not tested with Apache MPM worker and installing it on Debian/Ubuntu will lead to removal of
If you still wish to switch to
module, it is sufficient to uncomment this directive in
# grep HTTPD= /etc/sysconfig/httpd
and restart Apache:
# /etc/init.d/httpd restart
Note, that the worker MPM assumes a special PHP module to be configured/loaded by the Apache webserver:
# cat /etc/httpd/conf.d/php.conf|grep -A3 "worker.c"
LoadModule php5_module modules/libphp5-zts.so
In the end, the question that is frequently asked by customers and engineers is: how to determine which MPM module the server is running on?
utility to determine the command line of running Apache process:
# ps aux | grep -v grep | egrep "apache|httpd"
root 1684 0.0 1.4 284484 14888 ? Ss 17:52 0:00 /usr/sbin/httpd
apache 3101 0.0 0.7 284484 7596 ? S 18:02 0:00 /usr/sbin/httpd
and check which module it is running by using this command:
# /usr/sbin/httpd -l | egrep "prefork|worker"
# grep -B 5 HTTPD= /etc/sysconfig/httpd
# The default processing model (MPM) is the process-based
# "prefork" model. A thread-based model, "worker," is also
# available, but does not work with some modules (such as PHP).
# The service must be stopped before changing this variable.